Aruba Networks Access Point Aruba AP 60/61 Specifikace stáhnout pdf (Strana 13)

Spectralink VIEW Certified Configuration Guide: Aruba Networks

721-1002-000_AB.docx

March 2015 13

Connecting to the Mobility Controller

Via console

Using a standard RS-232 cable, connect the Aruba mobility controller to the serial port of a

terminal or PC.

Run a terminal emulation program (such as HyperTerminal™) or use a VT-100 terminal with the

following configuration:

Bits per second:

9600

Data bits:

Parity:

None

Stop bits:

Flow control:

None

Use this mode of connection during the initialization phase of the controller to configure login

credentials.

1 Press Enter to display the Aruba mobility controller login screen.

2 Enter the default login: admin and the default password: admin. These are case

sensitive.

3 Enter enable and the default password: enable to get into the command mode.

Via the Command Line Interface (CLI)

By default, only SSH (Secure Shell) access to the switch (mobility controller) is permitted.

1 From a management system that has network connectivity to the switch, connect to the

switch using SSH

ssh admin@<switch IP address>

2 Enter the admin password at the password prompt.

Type enable at the > prompt to enter the enable mode.

3 Type the enable password when prompted for a password.

Via the Web interface (WebUI)

Once the connectivity to the switch is verified, open a Web browser and enter the switch’s IP

address in the navigator bar.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 122 123

Žádné komentáře

Aruba Networks Access Point Aruba AP 60/61 Specifikace Strana 13